KayFun Lite/Lite Plus Clone (EHpro) Question

Status
Not open for further replies.
Can anyone comment on the draw/vapor production on this? I am planning on either getting the Lite or Lite Plus, not sure which to get.

The vapor production is quite nice, I haven't received my mechanical mod yet so I have this exact clone on my provari and svd. I'm finding that the draw is far too tight compared to my buddy's legit kayfun and russian... Mouth to lung hits are fine but lung hits are tough for me to accomplish. I'm going to see if I can drill the airflow hole a bit bigger but I might end up breaking the damn thing. What to do, what to do...

I took this in the office just now, it's just a micro coil with cotton measuring at 1.1 ohms on an SVD running at 15 watts:
EHpro Kayfun Lite Plus Clone - YouTube
 
Last edited:

sparc

Senior Member
ECF Veteran
Verified Member
Dec 16, 2013
114
388
West Side till I die
I have the kayfun lite+ (non clone) and I like it. I'm more of an airy draw person and the kayfun lite+ works well with a chimney coil build, air hole opened all the way to allow max air flow. I'm using cotton and the flavor is good.


image by kiu101, on Flickr


kayfun lite+ by kiu101, on Flickr


kayfun lite+ by kiu101, on Flickr
 
Last edited:

kabonk

Vaping Master
ECF Veteran
Verified Member
Nov 1, 2010
4,582
4,507
NW Detroit Burbs
The vapor production is quite nice, I haven't received my mechanical mod yet so I have this exact clone on my provari and svd. I'm finding that the draw is far too tight compared to my buddy's legit kayfun and russian... Mouth to lung hits are fine but lung hits are tough for me to accomplish. I'm going to see if I can drill the airflow hole a bit bigger but I might end up breaking the damn thing. What to do, what to do...

I took this in the office just now, it's just a micro coil with cotton measuring at 1.1 ohms on an SVD running at 15 watts:
EHpro Kayfun Lite Plus Clone - YouTube
when I got my ehpro kayfun lite clone the draw was really tight compared to my Russians when I took it a part I discovered a tiny piece of plastic was blocking the air chamber on the post I poked it out with a paper clip. worth a look if you haven't yet
 

Gigdujour

Ultra Member
ECF Veteran
Verified Member
Jun 9, 2013
1,919
12,490
Michigan
Didnt know there was a kfl+ clone already out.

The clone I picked up in the classies has a little allen screw to adjust the air flow on the base.
vyteda3u.jpg

I'm a Kayfun noob so I'm not sure if that makes it a + or not.


Master of Bassets...and not much else.
 

Bill's Magic Vapor

Vaping Master
ECF Veteran
Verified Member
Feb 8, 2013
4,493
11,078
USA
When the Kayfun Lite Plus came out at $99, this became a no-brainer for me. I like to support original producers (SvoeMesto), and it encourages innovation in VapeLand. Prior to the PLUS, you had to buy the 3.1 to get the air flow control. I got both, and preferred the 3.1 because of air flow control. I preferred a slightly tighter draw than what I get with the Lite. Now the PLUS has AFC, and the 3.1 is discontinued (according to C9V). I heartily recommend the SvoeMesto KFL PLUS. Wish it was out before I bought the other two. Good luck to you. My two cents. YMMV.
 
Status
Not open for further replies.

Users who are viewing this thread