hey guys, i've been using my kayfun lite clone on my mvp v 2.0 for the past 3 weeks and today i went to screw it onto my mvp and it won't thread or even make contact with the screw threading on the mvp. Every other tank works fine any suggestions? also if i need to replace the kayfun base does anyone know of any websites that sell clone parts?
Kayfun Lite won't thread onto 510 connection?!
- Thread starter johnnyq14
- Start date
- th_trl_thread_readers 0
- Status
Was it dropped? Check for burrs on threads. My best guess is some of that base threading broke off. Did you try to attach it to any other device? As for part 2 of your question I haven't seen any parts for kayfun other then a few tanks and o-rings if you can find them in stock. Probably easiest to just buy another one. I picked one up a knockoff last week from 101vape.com and it was here in 5 days for 32 bucks. Not to shabby from west coast to east coast. I did just check they are out of stock there sry.
Thanks for the link, and I never dropped it and i tried it on my other devices and it screws no problem. looks like i might need to get a new mvp.
Check the upper most threads on the MVP for damage. Not impossible to strip if you have 510 devices on/off a lot.
Did you do a Kayfun rebuild? Check that the center pin isn't sticking out to far. Bottoming out before threading down.
Did you do a Kayfun rebuild? Check that the center pin isn't sticking out to far. Bottoming out before threading down.
One of these may help you save your mvp if indeed the threads are giving up on it. Screw this air flow controller on your mvp and leave it on. Then just screw your tanks into the air flow controller and save your mvp threads from any further wear. I do this on all of my mods to save the soft threads.
Tank Airflow Controller for 510-Threaded APVs
- Status
Similar threads
