I recently purchased a kayfun lite clone at a local vape shop (big mistake as usual), it took some tinkering, but i managed to get it vaping like a dream.. there is one issue though. The threads for the fill hole screw seem to be stripped.. The screw will tighten.. but when I attempt to remove it, it just spins. I ended up having to get a piece of wire to wrap around it and pull it out whilst unscrewing. I placed some teflon tape over and it its working fine.. for now. Is there anywhere I could buy a replacement atomizer base assembly for a kayfun clone? Or is there a way I can fix the threads? Thanks!
Stripped threading on fill hole of kayfun lite clone.
- Thread starter HeySoulFrog
- Start date
- th_trl_thread_readers 0
- Status
Oh btw, I have also tried several replacement screws they had at the store that I purchased it from.
I would suggest going one size bigger screw from hardware store and gently try to rethread it. Just make sure you are going with the correct threads, just a bigger size.
I would suggest getting a good quality clone like the Ehpro, about 35-40 bucks. Use the one you have for spare parts.
$12.87 Kayfun Lite Styled Rebuildable Atomizer (4.5mL) at FastTech - Worldwide Free Shipping, cheap enough to buy just for the base
- Status
Similar threads
