Kaze RDA problems

[stevenng87]

Hi everyone,

I have recetly purchase a Kaze rda from CKS/Aria Build, but when I started to build on it (24ga 6 wrap dual coil, 0.29oHm), it has become extremely hard to inhale(suck the vapor up?) and very hot vape, then the rda itself gets super hot, and when I drip more than 20 drops in it, it starts to leak on me from the bottom, I thought it is suppose to be a leak proof RDA? I got mine from Mid Land vaping.com.
Wondering if anyone has the same problems and any fix? or did I get cheated by buying a clone one?
appreciate in advance

 

[Katmar]

Hi Steve and welcome to the forum. Let's bump you up for an answer. Good luck to you....

 

[stalkster]

I don't own one but looking at a 5min video of the design.

"hard to inhale"
Make sure your set in dual coil mode or single coil.(Single coil is gonna be a high air restriction)
Make sure the inner barrel air slots are not obstructed by your Wire/Cotton.
It's dose seem overall to be a somewhat restricted draw.

"RDA itself gets super hot"
If the airflow is obstructed it can get hot faster.^
The RDA dose not seem to keep cool if running a hot build since A:Somewhat restricted Airflow. B:The inner barrel section design.

"starts to leak on me from the bottom"
This sounds pretty simple, once the juice reaches above the deck it overflows onto the outer barrel section and then leaks between the base and outer barrel section due to bad/worn/damaged/not proper sized O-rings.