KFL+ V2 Going to waste

[militiascene]

So, lately I have been dripping a lot. When I say a lot, I mean 30 mL a week almost and hooked on this Stillare! I now have an EHPro KFL+ V2 that is sitting in my bag as a backup and just aging.
I want to be able to use it again but when I try, even with the adjustable airflow, it just doesn't do it for me like a good rda. Is there any way to drill out the airhole for the KFL to loosen up the drag a little? I don't want that $35 piece to just become a paperweight.


Places I drip: At home, at work, in the store, outside, in my car, on my bike, in church, at the bowling alley, at my friends', at my parents', at my girlfriend's parents', at your girlfriend's parents' (oops....)

 

[maf2k8]

You will for sure need a drill press in order to do any drilling on a Kayfun. There not as easy as say enlarging the air hole on a dripping atomizer top cap.

One thing i have always wanted to do was to pick up a clone KFL and try enlarging or making the juice channels deeper. I am curious as to what benefits (if any) the KFL would have if the juice channels were wider or deeper then stock.

Also, If you prefer to drip, You can drip using your KFL. Check out the thread in this forum. A few members along with myself have setup our KFLs to be used as drippers.

 

[militiascene]

You will for sure need a drill press in order to do any drilling on a Kayfun. There not as easy as say enlarging the air hole on a dripping atomizer top cap.

One thing i have always wanted to do was to pick up a clone KFL and try enlarging or making the juice channels deeper. I am curious as to what benefits (if any) the KFL would have if the juice channels were wider or deeper then stock.

Also, If you prefer to drip, You can drip using your KFL. Check out the thread in this forum. A few members along with myself have setup our KFLs to be used as drippers.

I love using my Stillare for dripping though because of the massive and adjustable airflow along with gold plated posts. My next dripper will probably be an IGO W6. I'm starting to look at some 26650 mods now too along with 28.5mm RDAs.

 

[classwife]

Moved to Rebuildable Atomizer Systems from the Modding Forum - Tank Mods

 

[brianc11111]

i wouldnt advise drilling a kfl unless youve got a great bit and a drill press......they arent as easy as the 3.1's to drill.
if you do.....5/64 for air channel under the wick......9/64 for the side