KFL + V2 vs V3

[Jdbaker82]

did anyone ever compare the two 1:1 to see differences? I notice the top Oring in my one seems impossible to replace as its in a space u cannot get to. chimneys are different sizes too. airflow seems same on both not as airy as the Russian 91% and that's really starting to bug me



Sent from my SCH-I545 using Xparent Skyblue Tapatalk 2

 

[Jdbaker82]

so if you totally cover up the side airhole with bottom airflow adjustment screw totally removed you get a airier draw.... this ... backward lol

Sent from my SCH-I545 using Xparent Skyblue Tapatalk 2

 

[weinner]

You have to cover the side?

 

[Jdbaker82]

You have to cover the side?

no but I'm saying the same side airflow on the KFL + V2 and V3 is what restrict the airflow without it you get a more airy draw just removing the bottom airflow screw..... it's really blah

Sent from my SCH-I545 using Xparent Skyblue Tapatalk 2

 

[BobFully]

V3? I didn't know there was a v3. what are the differences and where can I get one? TIA

 

[Shootist]

Wasn't ware of a Version 3 of the Kayfun Lite +. What I think you are looking at is the units from hcigar or Tobeco. I have 2 EHPro models one hcigar and one Tobeco.

The EHPro's have a drop down area in the top cap that holds the O ring. The hcigar and Tobeco don't. The stem on the Hcigar is shorter than the ones on both the EH and Tobeco. It almost doesn't cover the O ring. Working fine though.

Raise your coil higher to allow better airflow. On the units I have the coil just above the center air hole the draw is tight even with the airflow adjustment screw removed. The HCigar unit I have the side air hole is smaller than on the EH and Tobeco. On that one I do have the adjustment screw removed.

 

[Jdbaker82]

Wasn't ware of a Version 3 of the Kayfun Lite +. What I think you are looking at is the units from HCigar or Tobeco. I have 2 EHPro models one Hcigar and one Tobeco.

The EHPro's have a drop down area in the top cap that holds the O ring. The Hcigar and Tobeco don't. The stem on the Hcigar is shorter than the ones on both the EH and Tobeco. It almost doesn't cover the O ring. Working fine though.

Raise your coil higher to allow better airflow. On the units I have the coil just above the center air hole the draw is tight even with the airflow adjustment screw removed. The HCigar unit I have the side air hole is smaller than on the EH and Tobeco. On that one I do have the adjustment screw removed.

when with no coil when drawing I find the restriction comes from the airflow hole on the side of the KFL+ V2-3. To test it just cover the side airflow hole with your finger with the bottom airflow adjustment screw completely removed and then you will see how you get a nice airy draw... I find myself covering the stupid side airflow just to get a airier draw

Sent from my SCH-I545 using Xparent Skyblue Tapatalk 2