Kick V2 Not Firing

[Briguy82]

Hey guys and gals,

So I'm new to mech mods. I've been vaping on Pig Cigs by LeCig and a VV model. I recently purchased a KTS China GG, outfitted with a AGA T-2 rba. Also managed to build a successful coil coming in at around 1.5 ohms. Today I received my evolve kick v2. I assembled my mod and through in a CGR18650CH. Pushed the fire button and got nothing. I did hear a slight electrical draw coming from the atty. The website says with some mods you may need to sand the inner tube a bit to get a good connect. I did this until I could see the copper looking metal (not sure what it is exactly). Still nothing...

Unfortunately I can't fit a single 18350 into my mod. I thought I could but the telescope won't go down enough. Can anyone help me as I wait for altsmoke to reply to my ticket? I purchased the extender tube from Hoosiervapes as they say it's required when using a kick.

PS. The ground contact pins are operating normally I think, and I've tried a seep rate atty and turning the kick down in case the resistance was to high or low in the coil.

 

[tmcase]

If you have the wattage set too high for the resistance the kick won't fire. Try turning down the watts.

The KTS is suppose to except the 18350 so if it doesn't then I would contact the vendor which I see you have done. I don't know why you would need an extender tube for a 18350 telescopic mod with the kick. You shouldn't. You would need it if you were using an 18650 with the kick.

It's also possible that you got a bad kick. I would try it in another mech and see if it works but turn the watts down and work your way up.

 

[steved5600]

When you put the kick in does that contact touch the side of the Mech? Use a flashlight to check. Some mod don't like the Kick.