The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

King Mod clone, loose battery issue

Discussion in 'New Members Forum' started by VoidPunk, Jul 31, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. VoidPunk

    VoidPunk Full Member

    Jul 15, 2014
    CA, USA
    Hey guys, this is my second thread on this site ^^ I just received a shipment from Fasttech. I was so excited to use the king mod v2 clone i purchased until i put the battery inside and reazlied that it was a bit loose and shaky in there. Could it be that its just not meant to fit the green classic Sony 18650 Flat Top batteries? All comments are appreciated (= Thanks for your time.
     
  2. fuelfiredesire

    fuelfiredesire Full Member

    Jul 2, 2014
    Bedford, TX, USA
    does the top cap have a screw to adjust? or is it a spring?
     
  3. VoidPunk

    VoidPunk Full Member

    Jul 15, 2014
    CA, USA
    the top has a screw. the contact pin (That's what its called ,right?) cannot go any lower or it wont make contact with the atomizer =P
     
  4. tayone415

    tayone415 Ultra Member ECF Veteran

    Aug 9, 2013
    CA
    If it's made like the authentic on the top pin there's 2 adjustments, that may look like 1 if stuck together. The upper part is to hold the atty and make it flush and the one underneath that is for battery rattle, same as the King v1 which is a copy or clone of the Chi You and similar setup as the Vanilla mods with atty and battery adjustments.
     
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice