This is a great genesis-style atty. It is built to look just like the original and even has all the markings and logos. I do not have the original to compare this to so take this review to be for the clone only.
Pros:
- 3 simple screws for connecting the coils
- Positive post has 2 washers to easily trap the wire
- 2.5ml glass tank
- can be disassembled easily for cleaning
- dual adjustable airflow (fully open is equivalent to about 2mm) can have both open or just one as well.
- made of high quality steel
- 510 connection and 510 drip tip
- fill hole is big enough for some bottles to be used without a needle tip
- works with many wicks very well (I tested silica, cotton, and SS mesh with no issues.)
Cons:
- screws did not have consistent threading and would wobble and spin freely (threads would not grab). Had to use different screws from the hardware store.
- screws were also stripped on top, virtually making them impossible to use with the mini screwdriver that came with it.
- didn't come with extra o-rings.
- only came with the materials to make a single coil, instead of a dual coil.
Overall, I would recommend this to anyone wanting a nice genesis-style atty that wants a more compact design and smaller juice capacity. It vapes quite well without the need for drilling out the air holes. It handles sub ohm vaping very well. Just be aware that it may come with junk screws (though the threading in the base is just fine) and you may need to swap them around or change them out.
Pros:
- 3 simple screws for connecting the coils
- Positive post has 2 washers to easily trap the wire
- 2.5ml glass tank
- can be disassembled easily for cleaning
- dual adjustable airflow (fully open is equivalent to about 2mm) can have both open or just one as well.
- made of high quality steel
- 510 connection and 510 drip tip
- fill hole is big enough for some bottles to be used without a needle tip
- works with many wicks very well (I tested silica, cotton, and SS mesh with no issues.)
Cons:
- screws did not have consistent threading and would wobble and spin freely (threads would not grab). Had to use different screws from the hardware store.
- screws were also stripped on top, virtually making them impossible to use with the mini screwdriver that came with it.
- didn't come with extra o-rings.
- only came with the materials to make a single coil, instead of a dual coil.
Overall, I would recommend this to anyone wanting a nice genesis-style atty that wants a more compact design and smaller juice capacity. It vapes quite well without the need for drilling out the air holes. It handles sub ohm vaping very well. Just be aware that it may come with junk screws (though the threading in the base is just fine) and you may need to swap them around or change them out.
