Lacking vapour production Aspire Nautilus.

[jamesnew]

Hi all,

I have an aspire nautilus with the BVC coils - 1.8ohm. It has been going great since I got it after a few teething pains...but. Yesterday I put in a new coil (1.8) and I primed it as I have done it with my past 3 coils (dripped a little liquid onto the coil, non powered draws, let is sit, draws with airholes shut ect), but it is lacking in vapour production (less than I was getting with my old Aspire ET-S). It tastes ok, not great. It feels kinda dry.

Any ideas why and any ideas how I can solve this?

Thanks!

Edit: I have tried it at various volts - 3.7, - 4ish.

 

[Katmar]

Bump for an answer!! Good luck...

 

[Completely Average]

3.7 to 4 volts?

Try bumping the voltage up. Way up.


This is my Nautilus with a 1.8ohm coil at 5.8V:



I'm surprised it works at all at just 3.7V.

 

[Rixsta]

These bvc take a little longer to prime and for it to wick, I found it needed a full day before the flavour and vapour was any good. I vape mine on 13W and get a decent amount of vapour, I would of said loads of vapour but since using my mini and nano tanks, it's a bit of a come down...