Lambo 4.0 problems

Status
Not open for further replies.

braun

Full Member
Jan 15, 2013
6
0
Ontario
I've been using an L-Rider Lambo 4.0 for almost two months, and recently when I would check the battery voltage the number displayed on the LCD screen would change quickly, ie. I would see 4.0, 3.6, 4.2 in the span of one second.

Yesterday, it shows the battery voltage for all three of my batteries at 2.8v, even though they're freshly charged (confirmed with a multimeter). When I hit the fire button, the screen flashes as though the battery is dead.

I've thoroughly cleaned it inside and out, but no change. I'm quite disappointed as I got the Lambo 4.0 to replace my L-rider 1.0, which lasted 5 months before the endcaps broke and the internal battery leads were ripped off of the circuit board.

Has anyone else had this issue?
 

eddie1530

New Member
Jan 16, 2013
1
0
61
NM USA
I've been using an L-Rider Lambo 4.0 for almost two months, and recently when I would check the battery voltage the number displayed on the LCD screen would change quickly, ie. I would see 4.0, 3.6, 4.2 in the span of one second.

Yesterday, it shows the battery voltage for all three of my batteries at 2.8v, even though they're freshly charged (confirmed with a multimeter). When I hit the fire button, the screen flashes as though the battery is dead.

I've thoroughly cleaned it inside and out, but no change. I'm quite disappointed as I got the Lambo 4.0 to replace my L-rider 1.0, which lasted 5 months before the endcaps broke and the internal battery leads were ripped off of the circuit board.

Has anyone else had this issue?

I had my Lambo 4.0 for only 6 weeks and the light startedblinking on/off like the battery was to low and stopped working all together.Before it started that it would jump from 4.0 to 2.7 then back. I was ok withthat but now a soild brass well built piece of junk. They put great effort tothe outside but the inside was junk.
 
Status
Not open for further replies.

Users who are viewing this thread