lavatube 2.0 wont work with splitfire?

[tuscani53]

not sure where this thread should go dont start threads very often but anyways i have a lavatube 2.0 from young june and it has been working great however i just started using the splitfire tanks and it works fine on my ego but when i skrew it onto the lava tube it dosent work at all if i back it off 2 turns it will work also when its skrewed completly down it reads 0.0ohms and when backed off a bit it will read 2.4 and work im a bit lost here any help would be great!!

 

[alpman]

The center pin of the Splitfire may be a bit too long, causing a short in the LT connector. That's why it works when you back it off. The same issue happens on a couple of my VIVI Novas. Luckily for you, the Splitfire has an adjustable center pin. Use a flathead screwdriver to adjust the pin down by about 1 mm. I had to file my VIVI's.

 

[tuscani53]

ok i was thinking it had somthing to do with the center pin i have never adjusted one i did try to play with the center pin in the splitfire and it seems that no matter how much i turn it it dosent move at all ?

 

[tuscani53]

yea i can turn the center pin it just spins mabey i need to file it down ima vape all the liquid out and try to adjust it with it torn apart first