Lavatube and iClear 30b: is there a trick?

[Mashbot]

So, I picked up a 30b clearo, but I'm having issues vaping it on my lavatube 2.0. Sometimes it can't tell it's connected, and I get a reading of 0.0 ohm resistance. Other times it works fine. The 30b works fine on my Itaste vv and ego, and sometimes if I warm it up on them the lavatube will work right after. Is there a trick that doesn't involve swapping mods?

 

[Grizzly_Vapés]

I am not to familiar with the lava tube, but I am going to assume that this device does not have a floating center pin. You may have to take a small flat head screw driver and lift up the firing pin little by little very gently until you can screw on the tank and it fires without a problem. Different tanks have different lengths in connections and it may sit too flush on your device.


Sent from my iPhone using Tapatalk

 

[Mashbot]

Thanks, I'll give that a try

 

[v1ck]

It will definitely be either the pin has sunk on your iclear or you need to tweek up the pin on the lavatube.

Good luck i have had some battles with the 30b :/

v1ck.

 

[porkchopbun]

Just tried it right now (lavatube+30b) w/out my air flow controller, no issues...took two tooks with different wattage..
try re-seeding your IClear 30b coil, unscrew it and reinsert it back in.

 

[dorkydood]

I use a lavatube 2.5 with an i30b with no issues at all. As others have mentioned, check your pins.