Lemo drop airflow

[Spaggy]

So I made a trade on reddit for a lemo drop an was wondering if there methods of covering two out of three holes that are on the base... I already have the air flow screwed completely closed....for me it's still to airy!!!

 

[NOVA jon]

Tape one or two closed

 

[Robert Cromwell]

Yep just small bits of tape work fine for such things.

 

[Spaggy]

OK I was thinking that wanted too see if someone did something else

 

[mesamay2003]

Wow, you must like a tight draw!!

 

[doofy666]

Er, I suppose you are adjusting the airflow rather than the 510 screw?

 

[Spaggy]

Middle screw.... I normally vape a evod or smok4.0 which have tighter draws then rta

 

[daveid777]

Middle screw.... I normally vape a evod or smok4.0 which have tighter draws then rta

Turn that screw all you want, it should have no effect on airflow, it's the nut on that screw which adjusts the airflow. It has two small slits in it to assist with turning it. When I close my Drop all the way, I can no longer drag at all - there is no air flow.

 

[VaPreis]

Middle screw.... I normally vape a evod or smok4.0 which have tighter draws then rta

The piece with flathead screw slot is what tightens the center screw to the positive block on the deck. It shouldn't be loose at all. The ring around the outside of the screw is what should be adjusted. Clockwise to tighten the airflow.

 

[Spaggy]

Yeah that is the one I turn not the middle... Sorry misunderstood ya!