Lemo Drop question

[Zombo]

Does anyone know what size replacement screws are needed for the deck posts? I know it was mentioned somewhere on ECF, but after much searching, I haven't been able to find it. I want cheeseheads, and I'm getting sick of ordering them only to find out they are the wrong size.

 

[c3scott]

It actually might be the screw I found on my bathroom floor. I may be wrong but pm me and I'll send it to you if I can figure out pm.

 

[Zombo]

I have replacement screws, I'm just looking for a specific type to change over to. Thanks for the offer though.

 

[Hanha]

M1.6 x 3mm fits I think. same as kayfun or erlkönigin.

 

[Dobo]

18-8 Stainless Steel Machine Screw, Plain Finish, Cheese Head, Slotted Drive, Meets DIN 84, 3mm Length, Fully Threaded, M1.6-0.35 Metric Coarse Threads (Pack of 10) 18-8 Stainless Steel Machine Screw, Plain Finish, Cheese Head, Slotted Drive, Meets DIN 84, Right Hand Threads, Metric: Amazon.com: Industrial & Scientific

 

[Zombo]

Thank you!

 

[Zombo]

18-8 Stainless Steel Machine Screw, Plain Finish, Cheese Head, Slotted Drive, Meets DIN 84, 3mm Length, Fully Threaded, M1.6-0.35 Metric Coarse Threads (Pack of 10) 18-8 Stainless Steel Machine Screw, Plain Finish, Cheese Head, Slotted Drive, Meets DIN 84, Right Hand Threads, Metric: Amazon.com: Industrial & Scientific

They finally arrived. Wow.Just.Wow.

I can't believe I didn't order these months ago. They hold so securely that when I do the ol' tug and pull to break off the legs the coil doesn't even shift ( I used to have to brace it with my finger when I used the old screws).

If you're a fan of the V1 Lemos (can't speak for V2), and you prefer catching under the screw heads, then do yourself a big favor and order these replacements!