Hey everyone, I have been running the iGo-L on a pure mechanical mod and the performance has been more than great. However, there are a few things that I've noticed and have issues with:
1. Not all iGo-L(s) are the same. Some positive/negative posts are too high above the air hole, limiting the flow to the coil and decreasing vapor production. Easy fix though; filed down the posts to match up to the proper height. Has anyone else had this issue?
2. Adding on to the previous issue, some bottom posts that connect into the mod's brass connections are longer than others. Same easy fix, filed the post down to sit flush with my device (stainless steel "don").
3. I bored out all my air holes to 1/16th, however they tend to leak when I over saturate the wick. I have been interested in upsizing to an 1/8th, but—obviously—the leaking will only become worse. Has anyone found a fix for this, or is it just the nature of the beast?
Thanks for any tips.
1. Not all iGo-L(s) are the same. Some positive/negative posts are too high above the air hole, limiting the flow to the coil and decreasing vapor production. Easy fix though; filed down the posts to match up to the proper height. Has anyone else had this issue?
2. Adding on to the previous issue, some bottom posts that connect into the mod's brass connections are longer than others. Same easy fix, filed the post down to sit flush with my device (stainless steel "don").
3. I bored out all my air holes to 1/16th, however they tend to leak when I over saturate the wick. I have been interested in upsizing to an 1/8th, but—obviously—the leaking will only become worse. Has anyone found a fix for this, or is it just the nature of the beast?
Thanks for any tips.
Last edited:
