lookin for help on a vertical evod/protank rebuild...

[jotook24tovaip]

I saw a few vertical rebuilds and gave it a try with mixed results. Did one for my evod and pro mini 2 v2(.....!)the first two lasted about a load and a half (refills) and I haven't had one last that long since. Not sure if its not enough wick or to much, tighter coil, or wider coil, I just get leaks. I lost my place with the other post, can't remember the title/page (duh), so if you can tell me which one to read or give me advice I would be very happy. Thanks in advance, as always,
Joe

 

[Alter]

I tried a vertical microcoil build in my protank head. I wrapped my coil on a drillbit that was just able to fit through the hole through the positive pin. I wasn't impressed with the vertical coil or like you I had either too much cotton or not enough, it just didn't make me happy. I have that build in my vape stand right beside my side by side dual coil protank builds sitting dormant waiting to be tried again but who knows.
My vertical coil didn't leak or I didn't use it long enough to start to leak but it was more effort to make work than vape recieved in the end.

 

[ingerri]

is this the thread your looking for http://www.e-cigarette-forum.com/fo...-micro-coil-build-aro-evod-protank-heads.html im "subscribed" to it but haven't done it yet LOL

 

[jotook24tovaip]

Nope but it looks like a close match so I,all start reading...thanks. maybe it is the same post but I can't find my input...for the best I'm sure... lol!