Looking 4 Good Atomizer/Carto solution 4 Provari

[Biznessmeh]

Hey all about 5 months ago I switched from an EGO-T (used with carto's instead of tanks due to such cool smoke and overpowering flavor the tanks gave) to a Provari. I first used CE2 Rev 5 clearomizers until I became frustrated with the maintanence, and switched to a Torpedo tank; however although my torpedo tank solves almost all the problems of a standard clearomizer it has these red O-rings, and leaks like a SIEVE, I've tried everything up to soaking the o-rings in warm water before installation. The bottom line is it leaks =( and I use 100% VG. The top plug slides up possibly from the heat while each time you take a hit the bottom part rocks off; so by the 3rd hit you have VG rolling down the mod.

Whew; sorry for the rant. Anyway I have tried a few cartomizers/atomizers and my prime voltage is ~4.4v. So I was hoping someone might have an idea about which Cartomizer/Atomizer would work well on my provari. Also if anyone has any solutions for my leaky $50 Torpedo Tank I would love you long time =).

Thanks for any help folks.

 

[Biznessmeh]

Oh ya, I was also wondering if anyone has tried the new ~2600mah Provari battery. If so how much of a difference did you notice?

 

[Fazed]

I use boge 3 ohm carts in tanks I made myself out of syringes. Not the prettiest out there, but I have never had a leak. There is a thread on here somewhere on how to make them. Costs me about $2 per tank and about 5 minutes of my time to make them. Also, a 20cc syringe is about the same diameter as the Provari so it looks good, I think.

Sent via cellular communication device...

 

[Biznessmeh]

wow thanks Fazed. That looks very clean for a DIY. I'll definitly check it out. 2 ohm's sounds about perfect for my voltage as well.

-BTW I really like the carbon fiber look!

 

[dormouse]

And BTW this is the Provape section of ECF - you should find some discussion threads there about Provari

ProVape

 

[Vapoor eyes er]

Here's the vid:

wow thanks Fazed. That looks very clean for a DIY. I'll definitly check it out. 2 ohm's sounds about perfect for my voltage as well.

-BTW I really like the carbon fiber look!

 

[kabonk]

hi sorry your having such an issue with your tank, I use the 2600mah Provari batteries and they work great get about 1 1/2 to 2 days on a charge as far as tanks go I have a al liquinator, a j-tank, a smoktech DCC tank and a bunch of homemade syringe tanks. haven't had a problem with leaking yet. I do have a over wicking problem with the DCC cartos so I cut my smoktech tank down and I'm using SR boge carto in it now.

 

[tj99959]

wow thanks Fazed. That looks very clean for a DIY. I'll definitly check it out. 2 ohm's sounds about perfect for my voltage as well.

-BTW I really like the carbon fiber look!

With a nice VV why would you want to saddle yourself with the limitations of a LR (2ohm) carto? Just askin'
Or should I ask, why did you go to the expense of a Provari if you want to vape at such a low voltage?
Your Provari will "E-2" at about 5v on a 2ohm. (2.5amp)
With a SR carto you have the full spectrum of the Provari to play around in.