Looking for 510 connector .ipt files or drawings

[Gabe1291]

Anybody have any drawings, dim specs, or .ipt files for the 510 connectors? I was just curious, since I like playing with mod ideas in Inventor (since my skill at actually BUILDING mods is horrible >.<) but so far I haven't been able to turn up anything as far as a schematic with dims to make into an .ipt to use with my mods.

I can get the RCA style connector specs that I use....well have tried to use on some of my mods, but if I ever find a decent machinist around this area that I can get to make these it would be nice to have the 510 connection set-up for use on my normal pv's that I'm not ashamed to take out in public, lol.

Hoping one of my fellow modders can help me out on this.

 

[Gabe1291]

Even a rough sketch with the dimensions for the outer ring and the center pin would be nice, I can work it all up easy enough. I just need a dummy to get the sizes for the press fit holes width and depth an possible center pin replacement. I know there is a bit of variance due to the different manufacturers, and the best I can tell I need an 8.5-8.8 mm hole for the press fit, but not so sure on that.

 

[urquidezj]

I'll rip a 510 apart and get u measurements Monday.

 

[Gabe1291]

Ok, Thank You!! ^_^ If you want a copy of the finished drawing or the 3D file, just let me know. It'll be nice to have this, so when I get an idea for a mod I can start dropping all the pieces in, and actually see what it looks like first......and possibly how complicated it is going to be. I have a ton of the salvaged batt and atty connectors....but nothing small enough to actually measure them.

 

[Teach]

Anybody have any drawings, dim specs, or .ipt files for the 510 connectors? I was just curious, since I like playing with mod ideas in Inventor (since my skill at actually BUILDING mods is horrible >.<) but so far I haven't been able to turn up anything as far as a schematic with dims to make into an .ipt to use with my mods.

I can get the RCA style connector specs that I use....well have tried to use on some of my mods, but if I ever find a decent machinist around this area that I can get to make these it would be nice to have the 510 connection set-up for use on my normal pv's that I'm not ashamed to take out in public, lol.

Hoping one of my fellow modders can help me out on this.

e-Cig Thread Sizes and tap and die resources have been posted by puck... no ipts though.

 

[B-Rad_The_Mad_Vapr]

A china made 510 connector requires an 11/32" hole and the center positive pole is an average of 4mm below the top of the connector

 

[Gabe1291]

OK, here is what I've managed to work up really quickly on the Atty Connector from what you guys have posted so far. Tell me what you think, or if you have any other dimensions let me know, so I can work them into this. Still have no clue on the center pin for it though so it's not shown atm. Gonna put together one for the batt connector as well here in a bit. Tinkering with a mod atm and worked this up in about 5 mins, so I apologize if its a bit sloppy.