RDA LOOKING FOR A GOOD BUILD ON MY PLUME VEIL
- Thread starter VAPING_IRISHGUY
- Start date
- th_trl_thread_readers 0
- Status
22g nichrome 3mm screw drier 8 tight wraps dual coils chucks some clouds & flavors pretty good
24g kanthal twisted 3mm screw driver 6 wraps dual coils .4 ohms awesome flavor & clouds are good
24g kanthal twisted 3mm screw driver 6 wraps dual coils .4 ohms awesome flavor & clouds are good
Last edited:
What plume veil do you have? 1 or 1.5?
The plume veil 1 is a lil bit small for 22g its just to rowdy of a vape for such small airflow. The 1.5 has bigger airflow and more injection holes.
I use my plume veil for flavor now if you take the top delrin piece out and rock it wide bore its decent.
26g dual parallel coils seems like the perfect build IMO for the plume veil. 5 wraps around a 2.4mm bit or screwdriver vapes nice at .2 ohms.
Ive vaped 22, 24 twisted, parallel and all. Its so HOT in that chamber its unpleasant.
Get a bigger rda for clouds. My personal favorite is the mephisto v2. Im in love with it.
Hope I helped. Im currently rocking dual. 26g fused claptons in my plume veil.
Check my instagram richie_porter_vapes I post builds and some vids.
The plume veil 1 is a lil bit small for 22g its just to rowdy of a vape for such small airflow. The 1.5 has bigger airflow and more injection holes.
I use my plume veil for flavor now if you take the top delrin piece out and rock it wide bore its decent.
26g dual parallel coils seems like the perfect build IMO for the plume veil. 5 wraps around a 2.4mm bit or screwdriver vapes nice at .2 ohms.
Ive vaped 22, 24 twisted, parallel and all. Its so HOT in that chamber its unpleasant.
Get a bigger rda for clouds. My personal favorite is the mephisto v2. Im in love with it.
Hope I helped. Im currently rocking dual. 26g fused claptons in my plume veil.
Check my instagram richie_porter_vapes I post builds and some vids.
when you say dual parallel coils you are referring to 2 strands wrapped together right? ( total newbie question)
Yes 2 strands wrapped side by side tight. Always make sure that you keep them parallel side by side when you tighten your screws. You don't want them crossing and causing shorts.
Twisted 28ga dual coils, 2mm, 8 wraps each (contact/touching wraps). Should end up around .45 - .5 ohm. Run it at 65 watts. And use a chuff cap if possible. You will be blown away by the flavor. And the vapor production is well above average too.
This is the same build I used for chucking clouds, all airflow wide open.
That quad parallel build by rip is quite gnarly, so long as you're using the gplat, anarchist, or any high quality nichrome wire.
- Status
