RDA Plume Veil 1.5 builds

[MarineVapor]

I have the plume veil 1.5 on my IPV4S, and was wondering what anyone would recommend for builds. I have done dual coil, single coil and the "Sleeper Coil" so far.

 

[classwife]

Moved to rda from E-Cigarette Technical - Tips and Tricks

 

[Sgt.Rock]

Howdy,

That would depend a whole lot on what ohm reading you are shooting for!

More info will get you some helpful answers!

 

[MarineVapor]

Howdy,

That would depend a whole lot on what ohm reading you are shooting for!

More info will get you some helpful answers!

so far I've kept in the .2-.4 range so anywhere in there. I'm not looking to go crazy low. just looking for ideas on new builds to try out for fun. I have 26 and 28 g kanthal coming this week.

 

[Sgt.Rock]

Have you run parallel coils yet? (wrap two strands per coil)

They allow you to use much more wire to achieve the same resistance.

Here's the data for a setup with dual 26s using Nichrome 80
Coil wrapping | Steam Engine | free vaping calculators

Try 'em..you may like 'em

 

[MarineVapor]

I HAV

Have you run parallel coils yet? (wrap two strands per coil)

They allow you to use much more wire to achieve the same resistance.

Here's the data for a setup with dual 26s using Nichrome 80
Coil wrapping | Steam Engine | free vaping calculators

Try 'em..you may like 'em

I have ran a single parallel not dual. I was looking at rip trippers 4 strand parallel coil. As much as I would like to mess around with the nichrome and titanium, I don't feel like im there yet hahaha. I've seen some pretty crazy builds from ppl that look way to complicated.

 

[BeerGolfClouds]

Since you're using a regulated mod, try using twisted 28ga. It's easy to do, take one long strand of kanthal, fold it in half, and use a drill motor with a hex key in the chuck to hold the looped end and a pliers to hold the two loose ends. Pull tight and pull the trigger. When the wire breaks at the hex key side, you're done.

I use dual coils with twisted 28ga on my Plume, each is 8 wraps around a 2mm bit. I run it at 65 watts, and the quality of the vape is amazing.

 

[MarineVapor]

Since you're using a regulated mod, try using twisted 28ga. It's easy to do, take one long strand of kanthal, fold it in half, and use a drill motor with a hex key in the chuck to hold the looped end and a pliers to hold the two loose ends. Pull tight and pull the trigger. When the wire breaks at the hex key side, you're done.

I use dual coils with twisted 28ga on my Plume, each is 8 wraps around a 2mm bit. I run it at 65 watts, and the quality of the vape is amazing.

I'll definitely give that a try thanks