ok so a buddy of mine gave me 10 expended .50 cal casings im looking to make a mod out of them (yea I know its probably been done!!!
) any suggestions?
) any suggestions?looking for ideas
- Thread starter stealfdawg
- Start date
- th_trl_thread_readers 0
- Status
Of all the .50 cal casings I've seen on an image search they looked tapered...could be tough to get a 14500 to slide in and sit right but if you could I'd do a side x side...at the very least the end would make a cool switch surround...one-up the .45 mag
thinking of side by side with switch in one primer well and atty connector in the other then using two more shells as bottoms. I cut one up a while ago and a 14500 fits sloppy so maybe larger batt with the tapered portion of the shells gone I could fit something with more girth I know a 14650 will fit but whats a little fatter?
Don't hold me to this but I think the first 2 numbers are a batts width (in mm) and the last 3 are its lenght, also in mm
Sent via priority one sub-space communication
Sent via priority one sub-space communication
Yes, you are correct. For example:
14500 = 14mm wide X 50mm long
14650 = 14mm wide X 65mm long
18350 = 18mm wide X 35mm long
etc, etc
And keep in mind on those measurements that protected batteries are often a mm or two longer (and sometimes a tiny bit wider) than the numbering indicates
14500 = 14mm wide X 50mm long
14650 = 14mm wide X 65mm long
18350 = 18mm wide X 35mm long
etc, etc
And keep in mind on those measurements that protected batteries are often a mm or two longer (and sometimes a tiny bit wider) than the numbering indicates
I believe someone here was making mods with shell casings - actually think he was also setting up as a supplier.
ETA: I did a search but couldn't find anything
I think I saw something...somewhere....some time....maybe
ETA: I did a search but couldn't find anything
I think I saw something...somewhere....some time....maybe
Last edited:
I believe someone here was making mods with shell casings - actually think he was also setting up as a supplier.
ETA: I did a search but couldn't find anything
That would be Switched, now a registered manufacturer. Last seen in these parts with: http://www.e-cigarette-forum.com/forum/battery-mods/161695-26650-26500-a.html
And here's a 308 mod: http://www.e-cigarette-forum.com/forum/ikenvape/194410-calibre-series-how.html
Looks like it is mostly turned parts that look like a bullet, and finally 11 minutes into the video *IS* vented, whew.
- Status
Similar threads
- Locked
