Looking for Some Advice...

Status
Not open for further replies.

Mark00Nichols

Full Member
May 7, 2017
7
5
43
Trying to figure out a Dual Coil Clapton Build that I can run around 45-55 watts...
Prefer Kanthal, but will use 316L Stainless...Suggestions ?

The only thing I have found close is a 26/32 Kanthal...5wraps around a 2mm bit...they are tiny tiny coils... Would prefer at least a 2.5mm diameter...

Running them on a 24mm Goon rda. And an hcigar VT75 nano.
 

Mark00Nichols

Full Member
May 7, 2017
7
5
43
All depends on gauge of wire.

www.steam-engine.org is your best friend, use the ohms law and coil wrapping sections.

Sent from my Nexus 6 using Tapatalk
Thanks for your reply...I use Steam Engine...And understand it depends on what wire you use...Just curious of others experiences, and advice on builds that people run at those wattage...But, Thanks !
 

r055co

Ultra Member
ECF Veteran
Verified Member
Dec 24, 2015
1,948
5,797
Seattle
Thanks for your reply...I use Steam Engine...And understand it depends on what wire you use...Just curious of others experiences, and advice on builds that people run at those wattage...But, Thanks !
I run a Goon on my series mods with 30x2/38 Kanthal around 3mm di 0.6 ohms, one hell of a good Vape. Or a 30x2/38 317L SS around 3.5mm di 0.5 ohms another outstanding Vape.

Sent from my Nexus 6 using Tapatalk
 
Status
Not open for further replies.

Users who are viewing this thread