Howdy folks,
So to assist me in not spending money on new devices, I'm going to try my hand at making a few. I'm a pretty handy guy, work with wood and jewelry, so no intimidation here, but this will be a whole new arena.
My first few attempts will be a couple of flashlight mods and a couple of copper mods. I've read all I can stand to read as everything is beginning to be a repeat of previous information. But I have a question about switches that comes from inexperience.
We've all seen the little switches from radio shack that are used to fire the mods. They do the job, but to me, they tend to subtract from the overall look of an otherwise impressive bit of work. I would like to use a different...unobtrusive switch that is available without tearing apart an existing device. Could someone point me in the right direction? Or maybe make a suggestion?
thanks folks,
Big Mac
So to assist me in not spending money on new devices, I'm going to try my hand at making a few. I'm a pretty handy guy, work with wood and jewelry, so no intimidation here, but this will be a whole new arena.
My first few attempts will be a couple of flashlight mods and a couple of copper mods. I've read all I can stand to read as everything is beginning to be a repeat of previous information. But I have a question about switches that comes from inexperience.
We've all seen the little switches from radio shack that are used to fire the mods. They do the job, but to me, they tend to subtract from the overall look of an otherwise impressive bit of work. I would like to use a different...unobtrusive switch that is available without tearing apart an existing device. Could someone point me in the right direction? Or maybe make a suggestion?
thanks folks,
Big Mac