Looking to drip

[firemanjay]

Hello,
One of my batteries is an innokin Cool Fire I, is it possible to drip with this battery if i just purchase an Atty? If not what would be an inexpensive beginner setup to get into dripping?
looking to keep the cost around $50 to $75
Thanks for the advice.

 

[Starseed]

It depends of the resistance of the coil you build. So you need to determine what size your battery is, the volts, mah (miliamps per hour), and max discharge amps. It will look something like this Sony US18650VTC5 2600mah HIGH DRAIN 30a. For safery precautions watch some youtube videos on sub-ohm vaping, battery safety and building atomizers. Always make sure you know how much amps your battery can handle and dont push it more than 40 percent at most.

 

[zccool4718]

I have a nimbus dripper and its does fine with those type of batters, (not the mod, the batteries you put in it). So all in all just get your self a dripper and your be fine.

 

[firemanjay]

Thanks for the info
The MOD is the Innokin Cool Fire I
The batteries are:
2 - Efest IMR 18350 800mah High Drain (no amps info on battery)batteries
1 - Efest IMR 18350 700mah High Drain 10.5a battery

So from what I can see these would be too small to drip?

 

[Tinkiegrrl]

As long as you keep the resistance of the coil at 1.3 ohms or higher, you'll do fine with a dripper. I recommend one meant for a single coil, rather then a dual coil though. A dual coil dripper may have a bit too much air flow for a standard resistance, single coil. An Igo L, or a Progen Vortex should be great with it. The Vortex is normally quite expensive, but vapervenue has them on sale on clearance. Great chance to get a higher end dripper at a really low price, and from what I hear, it is a genuine.

 

[Jvalles95]

Get an igo w and stick with higher ohm coils first, remember battery safety and check for shorts in your coils

 

[Millennial]

What is ''dripping'?

 

[The Ocelot]

What is ''dripping'?

It's dripping directly onto the coil, without the liquid being held in a tank. "Old School" dripping involves dripping a few drips at a time into a plain 510 or 306 type atty. It used to be the only way to drip, but is now primarily used as an inexpensive why to try out new juices - no building is required. What most people are referring to now when they say "Dripping" are RDAs, devices where you build your own coils and they tend to hold more liquid you you don't have to drip so often.