Macro coil in a kayfun lite?

[codyb88]

Have any of you ever built a macro coil in a kayfun before? I was thinking about rebuilding my KFL and wondered if it would fit and how the vapor/flavor would be compared to a micro.

 

[ShariR]

Try a search on it in the kayfun thread. I am sure plenty of people have done it. There are all kinds of coils talked about there.

http://www.e-cigarette-forum.com/forum/rebuildable-atomizer-systems/436118-kayfun-lite.html

http://www.e-cigarette-forum.com/forum/tips-tricks/479902-maxicoils.html

 

[steved5600]

Single or dual coil. If you go dual i would go with a 1/32 drill bit nano coil. 15 wrap of 30ga wire leads going in opposite directions. Then you just put the coils in LOL can be tricky. Make sure the leads especially the negative leads do not touch the other coils leads or the positive post. I'd use a small amount of cotton to much will clog it. If you need help doing this go to https://www.youtube.com/watch?v=P20dXHUQCJM
His is a lower resistance so it only uses like 10 wraps mine will work out to .9 ohms total resitance. You can do it single coil and it is not bad but the dual is not easy. This reviewer i posted also show a single coil that is great.

 

[tj99959]

I use a single micro coil in my KF. Get the resistance between 1.25 and 1.5 ohms. Make sure both legs come off the bottom of the coil, and the distance the coil is above the air hole makes quite a bit of difference. So adjust to your individual taste.