mechanical mod hot button help!

[junior28186]

hi, i bought a mechanical mod, its the drawtube....

after seeing a lot of people talking about danger related im a bit scared so i bought safety fuses and i think good batterys.

i have the drawtube that have a hot spring already in it plus i put a fuse, 18650 battery which i think is sony (its a green one vtc4 written on it)
a kayfun lite plus with a microcoil at 1.3 ohm.

so a couple of question regarding that build, is it ok to have a spring AND a fuse?

i should not over tight the battery in it because the spring become useless?

the firing button get warm sometimes, and the vapour production is slow to starts off.(i can hear a POP when that starts)


i chack the atomiser and it always read the same res so i think there might be a problem from the mod itself......

im i just scared for nothing or is it okay to continu vaping on it?

 

[steved5600]

My guess and that is all i can do with the info provided is that there may be problem with the resistance of the switch. Resistance causes heat. That is a SS mod and the resistance of the mod can cause it to heat up. Copper and Brass mods have lower resistance. Might see if there is an upgrade for the switch out there. One other thing to do is a good cleaning of the switch.

 

[Rickajho]

What Steve said. Did you clean it once you got it? These things have machining oil from the manufacturing process and you can't count on it being cleaned out properly when you get it. Clean all threaded parts - 91% isopropyl alcohol works well.