MK2 Black Extension Sleeve

[eunilnam]

Hey guys,

I'm a Korean ecig user and it's been more than 1 year since I started to vape.

Today, I want to introduce a MK2 Sleeve, which can make MK2 enable to vape at HV like 6v, 7.4v.

Take a look on the pictures below.



This sleeve is made by a Korean Ecig user, Heobeok.G.

It can make MK2 hold 18650, 18350 x 2, 16340(rcr123a, spacer needed),so it can run at 3.7, 6.0, 7.4v.

The first time I saw this picture, i was really impressed about the quality of the sleeve. Color is a little bit diffrent from an original MK2 body but it's still well made and fully functioning as well.

Very Impressing work.

Enjoy Vaping!

 

[gguripark]

Today I ordered this sleeve, too. I expect Heobeok. G to send them tomorrow.
Maybe MKII will be renewed with this sleeve.

 

[Stownz]

Too bad the button design on the MK2 (Screwdriver) is absolutely horrible. When the button falls off, and it will, the unit autofires until the atty burns up. In my case, it autofired in my shirt pocket, atty got so hot it burnt through my shirt pocket into my chest. The only way to turn it off once the button falls off (the spring for the pin pops off when the button does) is to unscrew the whole unit and get the battery out of it.

Nice to see you work, and modding units. Plz spend your time on something better then that horrible designed button unit.

 

[eunilnam]

Today I ordered this sleeve, too. I expect Heobeok. G to send them tomorrow.
Maybe MKII will be renewed with this sleeve.

Awesome. You gotta like it. now I regret that I sold out MK2...