Modding pin in King clone

[Kracker]

I just got a Stillare clone with a hella long 510 post and when I put it on my King it can't sit flush. Is it okay to grind down the positive post so it can screw down all the way ? The pin has a little nipple on it and was thinking of cutting it off and then trimming the insulator a little (the Stillare makes it back out as well) so the tip of the pin will stick out of the top........is this okay ?

My Trident is the only rda I can get on flush and don't plan on using it, even if I did I still could adjust it down ??



Didn't know if this was an rda or mod question ???

Thanks
Kenny

 

[anumber1]

I have not found anything my king clone cannot accommodate regarding a flush fit. This includes my Magma that also has a long 510.

When you thread out the top pin, you run out of threads? Can't back the center 510 pin of the king far enough out?

What clone? Mine is an EhPro.

 

[Kracker]

it's an Infinate...I screw the pins in as far as they will go when the atty is flush and when I screw it on to the mod it has a nice sized gap. When screwing the Stillare down it even makes the insulator back out some.

 

[anumber1]

Dremel to the rescue!

 

[Bad Ninja]

Infinite clones are always a bit sketchy.
They were hyped to no end over their stingray clones before anyone even had one in hand.
There are scores of threads here complaining about switches and contacts in Infinite clones

I prefer Hotcig over infinite.