Modding the EHpro Kayfun Lite +?

[supersport13]

So, after seeing a lot of info on the KFL+ black edition and it being an improvement over other clones, has anyone tried making the juice channels bigger with say a Dremel tool? Or possibly drilling out the airflow with a small drill? I have the EHpro and would love it to more airflow but I don't want to fork over another 50 for a black edition. I want to try it so I thought I wouls see if anyone else has already tried it....thanks guys!

 

[300fury]

I have the black kfl+ and actually don't see a problem with the juice channels or airflow. It's a quality vape as is. My thoughts are that they are not really intended to be real airy. If I want more air and more vapor I go to my drippers. I think the point of the kayfuns and Russians is portability and solid flavor with a decent capacity for juice.... Everyone is different with their taste, that's just my opinion

 

[Tmartin63]

I was able to do both with great improvement on my kayfun clones. I used a Dremel to increase the juice channel size from the bottom up. And I used drill bits slightly increasing in size to enlarge the air hole. Then used a large drill bit to bevel the edge. I did this to cure the whistling issue not for airflow. Just be very careful drilling and not go too deep. Hope this helps.

 

[BobFully]

I dont think the blacks need modifications, they might if you prefer a very airy flow which could diminish flavor, if you make the juice channels too big you end up flooding which basically ruins your kayfun