Mom and Pop Min-Sub Tank w/Boge 3.0 carto w/ THREE punch holes works AWESOME

Status
Not open for further replies.

AZCraig

Unregistered Supplier
ECF Veteran
Dec 24, 2011
750
210
Mesa, AZ
www.KidneyPuncher.com
*** I just looked at the carto again and the sticker on the tank was blocking my view of the FOURTH punch hole. I can't seem to change the post title. ****

I got a Mini-Sub tank w/Boge 3.0 carto from Mom & Pop Vapor Shop.

When I unpacked it, I noticed that the carto has FOUR holes punched into it.

I loaded the tank with Ms T's Snickerdoodle 14mg (aged 3 weeks) and then dripped about 5 drops into the top... (just cause.)

I sat the tank aside for 2 hours and then mounted it on my Provari @ 5.5 volts.

I'm absolutely AMAZED at the vapor and flavor out of this setup.

The four punch holes are not big, in fact they are only slightly larger than holes on the SmokTech cartos that come with the SmokTech tank.

The only other carto mod that has ever wet the filler material this well was when I dremel'd a slot into a Boge 3.0 carto.

So whatever tool/technique Mom and Pop is using to punch their carto's that they sell with their tanks, it is right on the money.

FWIW, there is also a chance that some of the "Boge" carto's I've bought aren't real "Boge" and I've just finally gotten my hands on a genuine Boge again.
 
Last edited:

AZCraig

Unregistered Supplier
ECF Veteran
Dec 24, 2011
750
210
Mesa, AZ
www.KidneyPuncher.com
Where are these 4 holes punched? I just bought a carto puncher and am planning or more than two punches, especially for Boba's Bounty.

Y'all think it would make sense to have 2 at the bottom and two a little higher up to keep more of the filler moist instead of just the bottom half?

All four are about 1/4" above the internal edge of the endcap near the battery.

Pretty strange but it works really well !
 
Status
Not open for further replies.

Users who are viewing this thread