More miniprotank problems

[TheProphet]

Okay so yesterday I was finally getting tired of my ADV so I cleaned out my tank and filled it up with a different flavor. Put a stock mini protank coil into it since it was late at night and I didn't feel like rebuilding a coil. Try to hit it this morning and it won't fire. It's not my battery because it's working fine with my GSH2 tank. Is it just a dud coil?


Sent from my iPhone using Tapatalk

 

[hudson_macbeth]

What type of pv?

 

[flbutterfly1]

Check to make sure the contacts are dry between battery and tank. Make sure head is tight. Also make sure the little o ring on new head on the screw in part is in place.

 

[TheProphet]

What type of pv?

EVOD VV

Check to make sure the contacts are dry between battery and tank. Make sure head is tight. Also make sure the little o ring on new head on the screw in part is in place.

Contacts are dry, o-ring is in place, and the head is tight.


Sent from my iPhone using Tapatalk

 

[hudson_macbeth]

Have a multimeter?

 

[TheProphet]

I don't, at least not with me. My dad might have one at home though.


Sent from my iPhone using Tapatalk

 

[Dampmaskin]

Try pulling that center pin on the bottom of the atomizer head out half a millimeter. Be careful not to pull it all the way out.

 

[hudson_macbeth]

Ah. If you can get hold of one, set it to ohms, touch one lead to the threaded portion of your tank, one to the center pin. If no reading, coil is bad

 

[TheProphet]

Try pulling that center pin on the bottom of the atomizer head out half a millimeter. Be careful not to pull it all the way out.

I'll try that after class, thanks

Ah. If you can get hold of one, set it to ohms, touch one lead to the threaded portion of your tank, one to the center pin. If no reading, coil is bad

Alright. If he doesn't have one my MVP gets here tomorrow so I can check it on the ohm reader there.


Sent from my iPhone using Tapatalk