more newbie questions

Status
Not open for further replies.

jdimasi

Full Member
May 27, 2015
19
3
51
Hi al I was wondering what would be my best bet to get the must flavor out of my juice. What I have is a eleaf 50w I am useing a kanga subtank mini . I do 5 wrap coils with 26 g kantal . My eleaf reads .6ohms. I vape at 17 to 22 watts depending on the air flow I am useing. Any suggestions on hardware or wires any suggestions will do to get the must flavor .
 

sofarsogood

Vaping Master
ECF Veteran
Oct 12, 2014
5,553
14,168
Until I week ago I had the same setup as you, iStick 50, Kanger sub mini with rba, 1.5 ohm coils, 16 watts. Last saturday I got my first dripper, a tugboat v2 clone and started using it on the iStick with the same ohm coils and same 16 watts. I haven't used anything else since. Two more dirppers, Achilles and Derrigner clones are on order. If you had asked me a month ago I would have been certain I'd never have a dripper. The flavor is as good or better. I also like the control it gives me. Part of the reason the flavor is better is the tugboat is much quicker to service so I do it more often.
 

jdimasi

Full Member
May 27, 2015
19
3
51
Until I week ago I had the same setup as you, iStick 50, Kanger sub mini with rba, 1.5 ohm coils, 16 watts. Last saturday I got my first dripper, a tugboat v2 clone and started using it on the iStick with the same ohm coils and same 16 watts. I haven't used anything else since. Two more dirppers, Achilles and Derrigner clones are on order. If you had asked me a month ago I would have been certain I'd never have a dripper. The flavor is as good or better. I also like the control it gives me. Part of the reason the flavor is better is the tugboat is much quicker to service so I do it more often.
So u prefer a dripper what kinda coils do you do what size wire
 

roxynoodle

Unregistered Supplier
ECF Veteran
Jun 19, 2014
15,344
37,213
Ohio
What about the mutation x v4 it seems cheap anyone try it yet I don't wanna drop to much on some thing I don't have alot of experience with this one seem easy and has good reviews anyone try this one yet

Go take a look around the RDA area, which is a subforum of Rebuildables. The Mutations are very popular, and I'm sure there's a lot of info there.
 
  • Like
Reactions: jdimasi

kr8mods

Senior Member
May 12, 2015
123
46
36
I would have to suggest the Troll rda by motofo. It has 4 post holes which are most excelant for beginners. Reall deep juice wells. Nothing worse than being new to drippers and hit cotton and be turned off. Its going to happen for sure but not as fast. Its authentic and you can find it under $40. Oh almost forgot about the airflow, its superior imho. I just got a mutation x v4 not to impressed.
 
  • Like
Reactions: jdimasi
Status
Not open for further replies.

Users who are viewing this thread