MVP not working help please!!

[skinny30]

So my MVP stopped reading all my tanks. When screwed down it would read 0.0 for the ohms. I could back off tank a little by unscrewing an it would read correctly but the tank would then be loose. I tried lifting up the center post of the MVP and that seemed to work for a bit on my mini pro tank 3 but when I try my aerotank and nautilus it doesn't work. Now the mini protank won't work and it looks like a small rubber band under the center post is out. Any ideas or help would be greatly appreciated

 

[roxynoodle]

Put this in since the pin will probably keep going down:
Circuit Board Spacer

 

[r77r7r]

If the tank read correctly when loose- doesn't sound like the post is flattened then. ?

 

[skinny30]

Put this in since the pin will probably keep going down:
Circuit Board Spacer

How would I get that under the post?

 

[skinny30]

Double post

 

[r77r7r]

Goes on top, I believe

 

[r77r7r]

If the rubberband doesn't work, you can ty floss around the shaft, or get an adapter to work.

 

[skinny30]

If the rubberband doesn't work, you can ty floss around the shaft, or get an adapter to work.

How much floss?

 

[r77r7r]

Dunno, wouldn't think more than 3-5 turns. ?

 

[r77r7r]

Here you go-
http://www.e-cigarette-forum.com/forum/blogs/capt-shay/6338-fixing-mvp-vv3-contact-issues-guide.html

 

[r77r7r]

more-

http://www.e-cigarette-forum.com/fo...thread-contact-clearomizer-mod-batteries.html

 

[skinny30]

hey thanks boss man

 

[Nick N]

Here you go-
http://www.e-cigarette-forum.com/forum/blogs/capt-shay/6338-fixing-mvp-vv3-contact-issues-guide.html

Used the "Danco 60 washer fix" less than a week ago on the Vamo and the MVP, screwed the Magma RDA clone on too tight. Works great for $2.27 (10 pack) but I was a little nervous when lifting the 510 pin. Watch the video.

 

[roxynoodle]

Yeah the little spacer sits on top. Haven't needed to do it but bookmarked that for if/when I had a problem

 

[skinny30]

Thanks everyone for your help. So pulled up the pin and wrapped floss underneath a few times and it works great. Should i be worried about the floss burning or causing any issues?

 

[DasBluCig]

Thanks everyone for your help. So pulled up the pin and wrapped floss underneath a few times and it works great. Should i be worried about the floss burning or causing any issues?

Shouldn't be any real "heat" at/on the pin area....
A SMALL bit of juice will likely "seep" onto the pin over time....so a floss swap-out would, IMHO, be prudent when this occurs to keep excess gunk at bay......
Happy (vaping) Trails!