MVP v2 acting up

[Rewind165]

hello and sorry in advance if im posting this in the wrong section.

Ok so last night right before bed i left my mini nautilus tank on my mvp 2. i had just finished refilling the tank

ok so last night before bed i decided to refill my mini nautilus and leave it on my new mvp v2 ( i had to run to work early in the morning). when i woke up the mini had flooded the entire tank down the side of my mvp. i wipped it down cleaned it, refilled the tank again and kept moving. vaped fine up until 20 min ago. now the VV setting keeps turning on and stays on until i press the button then it turns off. 2 minutes later turns on again. if i put it in VW mode it will just turn back on in VV mode at 3.5. did my mvp just die on me ?

oh also i dont even have to press the VV button to change it. if i lightly tap it with my nail it jumps up .2~.3

Any ideas on how to fix it?

 

[Smann245]

Disassemble, clean with rubbing alcohol, assemble. It can be taken apart, but that can be a bit of a pain. Good luck.

 

[Rewind165]

thanks Smann. i did open it(you are correct it is a pain to open) and when i did that juice that flooded from the tank came out of the bottom of the mvp. cleaned it as best i could but because i had used it through out the day after it flooded it fried out. i just chucked it and ended up getting a new one. now i just dont leave the tank on overnight. thank you for the advice though

 

[classwife]

Moved to Variable Voltage APV Discussion from APV Discussion