My First Build on a Dark Horse with questions...

[StealthBombing]

Hey guys so i just did my first build as I'm getting into the rda world and i have a couple questions, below are some pictures and I'm just wondering if i put enough cotton on this deck or how does my build look in general , the build is a 0.6 ohm. also one of my coils is not firing even though both the posts are tied down on the coils. also is there a reason why my dark horse doesn't sit flush on my caravela? I've tried adjusting the posts but this is the lowest it will go

thanks

 

[SomeRandomBloke]

Cotton looks fine to me as for it not sitting flush, try adjusting the center pin on the caravela

 

[SLIPPY_EEL]

this could be useless info But sometimes if you try to unscrew the 510 pin when your atty is screwed on tight the pin won't move, you have to undo the atty then back the 510 pin off on the mod then screw the atty on so it sits all the way down and then you can tighten the 510 pin back up to the atty.

 

[Idiah]

It sounds like you have a coil touching your cap. Make sure that you adjust your coils towards the center of the deck. The Dark Horse looks like it has room but the top cap has an edge inside the deck ring that you have to contend with so when you build wider coils you have to be aware of that. the best way to check is take your drip tip off and but the cap on without it so you can see closer inside and make sure that nothing is touching it.