My Nautilus leaked?

[philoshop]

Just curious as to why.
The Nauti normally sits on my Provari, but somehow I ran out of charged batteries. I temporarily put it on the MVP2 (with a charged battery) and dialed the wattage down to what was a good vape, but after about 30 minutes I noticed it was gurgling a bit. Soon after that I had juice running all over the outside of the MVP.
This has never happened in the 3 1/2 months that the tank has been on the Provari. Everything is back to normal now with the Nauti on the Provari and the Magma on the MVP.

Any thoughts on why this happened?

 

[choochoogranny]

Haven't a clue, Philoshop. I switch my Nauti's all the time from ProVari, to MVP, to iStick, to VaporShark, and no leaking. Hm-m-m-m, could it be that when transferring from ProVari to MVP you might have slightly untightened/unscrewed the base a bit? Breaking the vacuum?

 

[philoshop]

Thanks for the reply choochoo.
All I did afterwards was wipe everything down and put it back on the Provari. All is good again.
I don't have a clue.

 

[James Wilson]

Maybe you need to tighten in the coil a bit more too. Had a very similar issue with my Kanger Sub-Tank mini actually yesterday. I unscrewed the bottom (upside down of course) and make sure the coil. then make sure the tank was properly sealed and then wiped down my istick 30w with a damp paper towl and wiped down the tank's outside too and I was good to go.

 

[philoshop]

I didn't do anything to the tank except put it back on the Provari. For some reason it just didn't like being on the MVP. Maybe it's developed an innate intelligence that I don't understand.