My New EGO Evic... LOVE This Battery BUT......

Status
Not open for further replies.

crxess

Grumpy Ole Man
ECF Veteran
Verified Member
Sep 20, 2012
24,438
46,126
71
Williamsport Md
joyetech eVic

V .Voltage - Volts output - adjust for different resistance coils - Helps to maintain proper watts for equal coil temperature.
V. Watts - Auto adjust Voltage to maintain constant Watts as you switch devices with differing coil Resistance.
RVV, RVW allow you to custom tailor output over a given time.

Best suggestion, experiment and see what works for you.
I use VW and with the devices I use normally run 6.8-7.4 watts.
 

Radar2013

Super Member
ECF Veteran
Jul 2, 2013
520
619
Indianapolis, IN, USA
JoyeTech eVic

V .Voltage - Volts output - adjust for different resistance Coils - Helps to maintain proper watts for equal coil temperature.
V. Watts - Auto adjust Voltage to maintain constant Watts as you switch Devices with differing coil Resistance.
RVV, RVW allow you to custom tailor output over a given time.

Best suggestion, experiment and see what works for you.
I use VW and with the devices I use normally run 6.8-7.4 watts.

Thank You sir. I am using a 1.8ohm Bottom Coil on a EGO Kanger EVOD. I switched it over from 4.0VV to 7.0VW and a big difference again in taste and Vapor. I really like this battery... Found out the hard way though that, Unlike the EGO-C starter, you don't have to tighten the EVOD real tight. Just tight enough for the battery to recognize the Atomizer and a very small turn to make it a little more snug and that's it... Now I am really enjoying Vaporing....
 

NicoHolic

Ultra Member
ECF Veteran
Jul 13, 2013
2,034
4,435
USA
You've probably already discovered when you twist and hold the ring to the right, it changes between VV, VW, and the custom settings. When set on VW you twist and hold the ring to the left, it changes what the left side of the display shows: ohms/volts, time/date, puff counter. I set it on ohms/volts, which shows you what voltage the variable wattage setting assigned for the resistance and what that resistance was when read. One short click of the fire button will show the display without changing the power setting.
 
Last edited:

Radar2013

Super Member
ECF Veteran
Jul 2, 2013
520
619
Indianapolis, IN, USA
Well have been using this battery now for 24 hrs. I shut it off last night when I went to bed at 2 AM... Turn it back on when I woke up this morning. After 24 hrs it still has a 85% charge to it... I LOVE IT!. If I was still using my EGO-Cs I would have switched out batteries 4 times by now... This is great. I want to thank each and everyone of you who suggested this to me... Now I feel like a pro :D . EGO Evic 2600mah Battery with EGO Kanger EVOD tanks.... Life is much better now... LOL
 
Status
Not open for further replies.

Users who are viewing this thread