My Sigelei Mini 30 hits harder than my Cana Mod 30. Normal?

[Slackitude]

At 30 watts with an Atlantis tank, my sigelei Mini hits considerably harder (better) than my Cana Mod 30 at 30 watts. Is this considered normal? I was kind of surprised. Maybe it's just that running anything at its limit could provide different results?

I've been thinking about getting a sigelei 150 for coffee table use for exactly this reason.

 

[Cyrus Vap]

I don't have a Sig Mini but I can tell you my Cana 30 is somewhat under powered (30 watts on the setting will give me something around 26 watts depending on battery, charge level, resistance etc) so this maybe what you're experiencing, especially if the Sig 30 is dead accurate or even a hair over powered

do you have an inline meter you can use on both and see what you're actually getting?

 

[Slackitude]

I do not have an inline meter, I'll pick one up though. I'm sure it would be useful to have.

 

[Croak]

Yihi SX130 vs a cheap DNA 30 clone, no contest.

Plus, the SX130 does over-volt by about a volt for the first second, by design. Early implementation of their Hard mode function found on the SX350.

 

[Slackitude]

Interesting, thanks. I had no idea that the SX130 did the over-volt thing. I have found that I like the Mini 30 way better than my DNA clone by a long shot. Already bought a second one. Maybe I'll just relegate the DNA 30 clone to use with low-wattage stuff like my Nautilus tanks.

 

[herb]

The Cloupor chips are very inconsistent so it's no surprise you get inconsistencies with it . The YiHi chips are far better imo .

 

[Monotremata]

13w on my Sig Mini is definitely "hotter" than 13w on my Vamo v7. I had to back down a couple watts with mine..

 

[Slackitude]

It took me a while to figure this out. I like my Atlantis tanks with 100% VG run at 30 watts. Warm-ish vape, great taste. 30 watts on the DNA clone is clearly not pushing as much voltage/wattage/whatever because the vape is cooler and the taste isn't there at all. I'm sticking with the Yihi chips from here on out.

 

[ROBB23]

agreed! i have both also and sigelei mini 30 hits harder at 30watts 100%! havent touched my cana since i got this thing

 

[v1k1ng1001]

My Cana likes resistances north of 1.5 ohms for some reason. My 1 ohm coils do not fire so well. Meanwhile, when the battery drops to half, I notice it's not hitting as hard as when it's fully charged.

The Sigelei mini is pretty awesome and my Sigelei 50w v2 will be here any day.

Cana will be retired to backup.

 

[HDMontana]

I posted the same thing awhile back when I first got my Sigelei, so this doesn't surprise me.

HD

 

[tFOrRESTee]

I think it's normal that your Sigelei Mini 30 hits harder than your Cana Mod 30. It's only abnormal if ur sig mini hits harder than everyone else's sig mini.

 

[Foggyroomz]

I rock Sigelei box mods Only, I had the Clopour mini 30 actually 3 of them because the screens all went to sleep and wouldn't wake up. Finally I took the last one to the range and used it to zero in the new scope on my 308. I had IPV3 didn't like the fit and finish or build quality compared to the Sigelei. I'm Sigelei exclusively unless someone steps up their quality to knock them out the top. If concealment became an issue I would rock an I-Stick 50 for power with stealth ability.