My Vision Eternity is getting on my nerves, any pros?

[Dana G Birrell]

Hello all,

I have a Vision Eternity atomizer using an EGO Upgrade battery on Variable Voltage mode. For the first 4 weeks of using my atomizer, I had little to no problems with vaping. But now, getting into my third wick replacement, I'm getting really weak and unflavorful hits, along with what seems to be some sort of airflow blockage. I have cleaned the air flow tub under neath of the coil. I'm starting to think my ohm ratings on my coil are out of wack, this is something I could likely pretty easily resolve, but does anyone have any suggestions?

Also, what Ohm rating should I be looking for?

 

[pkj]

Hi Dana,
Lucky you to get 4 weeks of decent use out of your Vision Eternity. I have one and am not satisfied with the draw or flavor it provides. I cleaned it and it is back in the metal box. Going to eat dinner in a few minutes. Will pull it out, re-read the instructions and take a look at it to see if I can come up with some ideas for you.

What ohms you are at currently?

 

[Dana G Birrell]

I made an attempt to read the curent, and I broke the damn wires on it. So, upon replacement, I got everything in place, my ohm resistance is fluctuating horrible between 1.6 and 3. I can't keep my hands steady enough to get a proper reading. I'm only 25, why is this happening already!?

Edit, got a better angle and I'm reading steady 1.8-2.2

Looking like with that replacement, it's working a whole hell of a lot better. The last coil set I was using had a really long length of wire on it. I know my supplier personally, so he's replacing the ....ty coils that I received.

Does anyone have any recommendations on replacing the wick for the spike?

Edit: Looks like replacing the coil assembly fixed the flavor and vapor issue, but there is still a horrible air flow blockage, could there be a bunch of crud inside of the air flow tube that needs something ran through to pull out?

 

[Thrasher]

you can always try soaking it in some hot water then blowing through it to see if maybe its just juice clogging it.
i hated mine and sits in a drawer.

 

[pkj]

Hi again, Glad to read the coil replacement worked. Can you try running a needle through the air flow tube?

I searched the forum for info on the center wick. There are a few threads about the Vision Eternity. I did Not search / read through all of them. Those I did skim over that were requesting help, quickly turned into, "I don't use the Vision Eternity so go by a - - Fill-in-the-blank - - because that is what I use and they work great". hmm...You know how that goes Will keep my eyes open for the center wick issue and come back with links / info if I find something.

You might send of an inquiry to your supplier and see if they have a center wick solution / idea. Let me know, ok? ok.

 

[Dana G Birrell]

My supplier has yet to use the Vision to my knowledge. His focus is flavors, in fact he's the largest flavor supplier in the world. I did replace the center wick with a coil wick, though I think buying thicker silica from OKC would be a better route, which I will be doing next week and experimenting with spike wick lengths and other good stuff.