MyFeedomSmokes DIY Flavoring Percentage?

[Gonzo562]

Just bought some DIY flavoring from MFS. Bought Dunhill and Marbro. What percentage is good for these flavors? I was thinking 20-25% flavoring would be good but the less i can use the better. I'd be able to make more bottles. FIY I'd like to have a full rich flavor. I now i can start with less and just add more to my liking but though someone would have an answer.

 

[instamix]

You sure you bought flavoring and not e-juice? I didn't know they sold flavorings.
I've bought Dunhill and flue cured e-juice from them but never saw flavoring.


I just checked the site and still don't see any DIY flavorings.

by the way most people start with waaaay less than 20-25% with tobacco flavors...

 

[atty]

I found that percentage out real fast with menthol. I found a flavor like Apple or Maple was too weak at 15%, so I bumped up the menthol to 20%......big mistake. All flavors have their own concentration level. R & D never stops.

 

[dormouse]

It depends on the flavoring. Some flavorings are recommended at 5% some 10% some as high as 20%. If those were standard flavorings you could probably look up recommended percentages. I don't remember those names being offered by Flavourart or PA or Loranns.

It's usually recommended that you make 1ml using no-nic juice to get the flavor percentage close, then a 5-10ml bottle of no-nic if you want to fine tune the percentage. Then make your real juice.

 

[Gonzo562]

You sure you bought flavoring and not e-juice? I didn't know they sold flavorings.
I've bought Dunhill and flue cured e-juice from them but never saw flavoring.


I just checked the site and still don't see any DIY flavorings.

by the way most people start with waaaay less than 20-25% with tobacco flavors...

F%&K dang i bought Dunhill and Marboro with 0mg of nicotine. I figured i can mixing it in with nicotine. Is that correct? Using Dunhill and Marboro with 0mg to flavor my ejuice?

 

[Mayasveil]

F%&K dang i bought Dunhill and Marboro with 0mg of nicotine. I figured i can mixing it in with nicotine. Is that correct? Using Dunhill and Marboro with 0mg to flavor my ejuice?

Wellllllllll, sure you could just add nicotine. Keep in mind the flavor will be a bit diluted because of added dilution. PM me if you need more info.

 

[instamix]

well you could always buy some of the 48mg/ml stuff and mix them together to make 24mg/ml.

or just try them first to see if you like them before you buy more,I hated the dunhill because it had yeasty taste to it that I just couldn't get passed.
7 leaves flavoring from flavourart is very similar to dunhill minus the stale beer taste so if you like the dunhill you might give 7 leaves a try.(dunhill seems to be a luv it or hate it taste NO middle ground)