Nautilus reading 0.0? ...?

[painkiller0007]

So i get home from work. Set down my vamo and nautilus and work on my kayfun. Try to take a puff off of the nautilus which was just working and bam I get a low load reading. I check the ohm and it says 0.7. I recheck and it now says 0.5. Last check reads 0.0 . Less then 2 days old and worked fantastic up until now. Tried new coils and nothing will work. Put my PT on the vamo and it reads and works just fine.
So frustrated at the moment. Any ideas here guys and gals?

Sent from my DROID RAZR HD using Tapatalk

 

[painkiller0007]

If anyone is interested I did some deep research and found a few rebuild videos. Got them hitting real nice now. It looks like bad heads was the case. Now I have cotton rebuilds. And all is well

Sent from my DROID RAZR HD using Tapatalk

 

[painkiller0007]

Also if anyone is interested I think its my vamo....if I back the tank out a bit on the 510 it reads fine but it is a bit wobbly

Sent from my DROID RAZR HD using Tapatalk

 

[brandontmyers]

My VAMO will on read about half of my tanks. Most of them it gives a 9.9ohm reading. I haven't read too much into it since I have other mods but it does upset me a bit.

 

[painkiller0007]

9.9 usually means no connection so that should mean your not making contact from your head to your device or you have a blown coil.

Sent from my DROID RAZR HD using Tapatalk

 

[classwife]

Moved to Rebuildable Atomizer Systems from the Modding Forum - Atomizer Mods

 

[crxess]

User Error - over tightening a Device and crushing the center pin down. Thousands of us have done this.
Carefully lift the center pin with a bent paper clip.
Get a Tank support - threads on the ego threading - to lock the tank solid at a properly adjusted height.



The Vamo you save may be your own.