Nautilus unthreading are you having this problem as well?

[Remi Love]

I love the Aspire nautilus big time it gives me maximum flavor, I can load it with a little or a lot of juice it looks super cool and vapes very well. My problem is when I unscrew thew base the coil unscrews and stays crewed into the top tube and then I have to get all sticky and unscrew it myself by hand and put it back into the base where it belongs. i tightened the coil into the base with needle nose plyers in hopes it will not come undone anymore its a real pain in the but to have to keep unscrewing the coil from the top tube every time i switch flavors. I am wondering does anybody else have this problem?

 

[SHOCK COLLAR]

only a couple times but after multiple fills on a mini, just make sure the coil bottom threads are dry the wet top threads will have less unthreading resistance.

 

[Stinkytofus]

get the metal sleeve, its a one piece as opposed to a two piece

 

[Topwater Elvis]

Nope never had the head stay with the air tube, sounds like you're over tightening the tank to base.
Could be you need to clean the threads or the base threads are boogered up from over tightening the head with pliers.

Disassemble and clean everything thoroughly, dry, install head into base snug / tight with fingers, tighten tank to base just enough to prevent leaking.

 

[FRSguy]

You dont have to put it back in the base... you can screw the base directly on to the coil and the upper coil threads will tighten as well.
Its actually easier to fill it if it stays screwed in to the chimney portion of it as the coil blocks juice from going down in to the chimney and you can fill it higher without any problems.