Need a positive block for a KF 3.1 clone

Status
Not open for further replies.

anumber1

Super Member
ECF Veteran
Verified Member
Jan 14, 2014
948
709
NW Ohio
Title says it all.
My FT 3.1ES clone has a positive block that is machined poorly. The coil hold down will not tighten on the positive block.

I flipped it over and have the same problem from the other side. The screws are OK as both work on the negative side.

Where can I get a replacement positive block? I found kf lite blocks on eBay. The 3.1 is different. It has threaded holes in the side and is much taller.

Help?

Sent from my XT907 using Tapatalk
 
Status
Not open for further replies.

Users who are viewing this thread