Need advice for a7 and aga t+

[wertyxhts]

I am using a vamo v2. Going to order the a7 for dripping and the aga t+ for vaping my all day liquids. First time getting into rba.

Questions for a7:

1. Any other rebuildables atomizers that are worth getting over the a7?

2. What size wicks do I grab for these? 1mm? Best site to order them from? I was looking at ebay, but I don't know how the quality on those are.

3. What resistance wires should I get?

Questions for AGA T+:

1. is it worth it to get the T2 over the T+? I know its a difference between the glass and polycarbonate tank.

2. Whats the difference in mesh between the 325,400,500? Is it the difference in throat hits? I am going to vape 50/50 liquids.

3. I was planning to run the 400 mesh and 32 kanthal a-1 wire, hows that setup?

 

[eddiezheadiez]

I have an a7. Its pretty small and hard to work with IMHO. I just got the igo-L atomizer. Its wider and shorter than the a7 and has a pop on cap so you can move the air hole to your liking. I would highly reccomend this for a beginner to rba's. I also have an aga. IMHO its huge and heavy. Setting up any Genny is pretty much the same so no problems in that area. As far as wick diameter goes 1mm is fine because you can fold and loop it using different techniques.

What do you plan to use for wick? silica, cotton, hemp, cheesecloth, bamboo?

 

[wertyxhts]

I want to use silica wick.