Well, what a ride this has been. Ordered some goodies for myself, and they finally got here. I thought I had done enough research and read a lot on the tank forum so I would be prepared for how to get it going. Got a beautiful naked Phiniac clear "naked" tank. Got some ss boge cartos. I even punched them myself. It was an adventure in itself. I really thought the holes were big enough. Wrong, I wasted 2/3 of my new highbrow juice. I had so much juice on my hands, tshirt, lips and unintentionally drank a lot im sure. I did what my suggested, to put some juice on a q-tip around o-ring etc. I also filled the carto so It would not be dry, What a mess. I must have taken that carto out over 3 times. Spilled it all over when carto flew out. The tank kept sliding around spilling more. I was going nuts. I went on youtube to see if there were some how tos. I found a vid by PBusardos about slotting your cartos and loading them on a tank. Well his method was clear and easy. Got out my dremmel saw. I slotted them as he instructed. He was using boge cartos on a 3.7 vmax( think, similar to an ego or kgo like mine). He didnt prefill his carto, after slotting them, he slipped it in dryish ( think he put a bit of juice on the tank openings. Then he filled the carto with juice. He said to fill it and let it sit for about 30-40 minutes. It was so much easier to load it like that. I put the contact end in first. THis time the carto slipped in with no mess. I got my first good hit, followed by a few more. I noticed that after a long while the carto seemed like it was drying. I spin the tank and take a few dry hits without pressing the batt button and it seems to draw the juice in. And it tastes great, good vape etc. Im thinking I might go and make the slots a bit bigger to see if it flows better. PBusardos loaded his tank with Bobas bounty, a notoriously thick and hot juice. So we will see. I will update you all about the bigger slots. I slotted my boges horizontally right about the edge of the caps and o-rings as he instructed. Someone commented on the video and said he slots them vertically so there is more surface along the carto for flow. Maybe I will add a vertical one as well as the horizontal ones. Im tired and I have blisters on me fingers from the attempts to punch them with a hammer and nail. Those little threads on the nails hurt when trying to steady those rolly slippery cartos. I think im in need of a cup of joe and a good long vape.
