Need HELP Juggernaut questions?

[Meddler]

I recently bought a Jugg and noticed that it only vapes well with a freshly charged battery. I got out the multimeter and noticed .8 voltage drop with 1.3ohm coil . I'm guessing that is a bit much and I've read about Noalox but not sure if that is the way to go. Is there something that I'm missing? or any thoughts that might help. Also I was popping wire when using both 30 and 32 gauge kanthal with 3 loops. 4 loops seams to work but I'm not happy with the vape production.

 

[Meddler]

looking at my contacts and they are dirty and could use a cleaning. Whats the way to do that?

 

[Nitrobex]

As the battery drains there will always be a drop in preformance, when it gets below 3.7V-ish I don't like the vape and change the battery. To clean contacts I que q-tip and everclear. Voltage drop under load can depend on the battery, not enough information really to go on that one sorry. 4 wrap 30ga should be a whole lot lower than 1.3. It takes me 6 wrap 30ga to get 1.3... What are you missing, you could try a thicker wire (lower gague) like a 28 or a 33 twisted to 28 or flat wire or... The rba section is that way ---->