Can someone point me to video instructions on how to use the same wick/coil in both drip and tank mode on the AGI please?!
- Status
here is a good way to modify it. First you're going to have to find a brass tube thats its over the skinny part of the center post with a spring attaches and cut it to the size of the spring this eliminates the spring and your voltage drop next you need to drill out the WIC hole with the appropriate size drill bit for an eight thirty seconds tap this will make your wick hole 3 times larger and still allow you to put a set screw in it to convert it back to Drpiper mode . Next drill your air hole out to the appropriate size for your liking mine is point 76 or close to two millimeters
And that's it you're done the spring has been modded your wick hole has been drilled and re tapped and your air hole is to your liking. Within 8 thirty Seconds wick hole u can fit any wick u want and still use a set screw to plug it for dropped mode.
Once all of that has been done this becomes an amazing hybrid dripper Genesis
And that's it you're done the spring has been modded your wick hole has been drilled and re tapped and your air hole is to your liking. Within 8 thirty Seconds wick hole u can fit any wick u want and still use a set screw to plug it for dropped mode.
Once all of that has been done this becomes an amazing hybrid dripper Genesis
Or like in other said if you don't mind the tiny Wick hole and don't want to drill and tap it to be three times larger you can simply just cut a blunt tip needle 18 gauge to fit were the spring was and that is all you really need to do
but if you have the tools to drill out the wick hole and tap it. 8 / 32 it will allow you to use 1 / 8 and 3 mm size wix without any issues in Genesis mode and still be able to convert back to a dripper
but if you have the tools to drill out the wick hole and tap it. 8 / 32 it will allow you to use 1 / 8 and 3 mm size wix without any issues in Genesis mode and still be able to convert back to a dripper
No I think he means drilling a hole for a 3-32 tap which the drill size should be a 0.13600 inch drill bit or for the metric users use 3.4544 mm.
Using the wick & wire that came in the package, I made my first silica wick at 2.1ohms on the AGI in dripper mode... but I'm getting this horrible burnt taste. I don't have any hot spots. Any ideas?
the spring of the AGI gave a resistance of .9 ohms on mine. weak vapor no matter what build I did. so what I did is look for an old clearomizer and took off the center pole which is a hollow brass tube. perfect size to replace the spring that gives the problem to the AGI. cut 10.5 mm in length and replace the spring. now this mod has zero resistance. power goes straight to the coil. as you can see in the picture, the spring somewhat burned in the center part.
Quick question... On a Agi hybrid which is the positive post and which is the negative post?
I filled the spring with copper wires from an electrical cable, cut to lenght. Now resistence is 0, was about 0.8-0.9 ohms in tank mode.
- Status
Similar threads
- Locked
- Locked
