need help with atomizer

Status
Not open for further replies.

spencerjames

Full Member
Dec 13, 2014
21
2
Im relatively new to vaping, only been doing it for about 3 months, and I've always used a cheap low Mah battery,and cheap ce4 clearmizers. I've recently upgraded to an X6 battery, with a real tank por atomizer. I used it for about 4 weeks now, and was very happy. However I went to clean it, with warm water, and let it air dry over night. I reassembled the Atty, filled my juice back up and tasted a horrible burnt taste. I let the juice settle for a few hours to saturate the atomizer head, and tryed it again. Still burnt. I've tried it periodically, still no change. What did I do wrong and how do I get the burnt taste out??
 

djsvapour

ECF Guru
ECF Veteran
Oct 2, 2012
11,822
7,901
England and Wales
Two possibles.

1. Your coil is dead (burned out) unless you have put a new one in.. ?

2. You 'upgraded' to an X6? An X6 is an inaccurate $14 battery that starts on 4.2v and will quite often burn Kanger atomizers with low resistance coils.


The answer is almost certainly no.1, but just be careful choosing your resistance for the next set of replacement coils you buy.

:)
 
Status
Not open for further replies.

Users who are viewing this thread