Need help with my setup

Status
Not open for further replies.

Dioxyde

Super Member
ECF Veteran
Aug 31, 2011
405
328
Oregon
Well by new I dunno if you mean new to building or vaping in general but I hope you're educated on safety and have an ohms meter. To answer your question though, I generally get pretty good performance from about .5 resistance with a mechanical mod like that, your battery could technically go down to .2 safely, that is, if you want to drain it instantly (sarcasm). Try 26g kanthal with a 2mm diameter, 5 wraps or so. Use this website to figure out your builds:Coil wrapping | Steam Engine | free vaping calculators

And make sure you have on ohms meter to check your resistances before installing on your mod.
 
Status
Not open for further replies.

Users who are viewing this thread